ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 979 / 1168

Chapter 32 show Commands
Management Switch Card User’s Guide
979
The following table describes labels in this example.
32.3.48 show vlan Command
Syntax:
show vlan [< vid >]
or
show vlan < start-vid > < end-vid >
This command displays the current VLANs.
The following example shows VLAN 1. It is set to send untagged Ethernet frames to the Gigabit
Ethernet interfaces.
32.3.49 show voip h248 interface Command
Syntax:
show voip h248 interface <id>
where
This command displays the status of the specified H.248 interface.
Here is an example.
Table 384
show vdsl tssi Command Display
LABEL DESCRIPTION
near end/far
end
This shows the location of the line test. “near end” refers to upstream traffic, or traffic
from the CPE device. “far end” refers to downstream traffic, or traffic from the CO device.
tone
This shows the frequency in increments of 4.3125 KHz. Single digit units on the top row
are added to the units in tens on the left hand column to find the corresponding value in
the table. For example, to find the TSSi value for tone band 43, locate 40 in the left hand
column and 3 in the top row. The intersection of the column 3 and row 40 gives a TSSi
value of 5.
ras> show vlan
vid sub1 sub2 up1 up2
---- ----- ----- ----- -----
1 U U U U
3 - - - -
5 - - - -
101 - - - -
4094 T T T T
id
The number of the H.248 interface (1~16).
ras> show voip h248 interface 1
get interface fail