ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 195 / 1168

Chapter 8 Multicast Screens
Management Switch Card User’s Guide
195
8.5.1 Static Multicast Slot Screen
Click Multicast > Static Multicast in the navigation panel to display the Static Multicast screen.
Type a VID and a group IP and click Apply to display entries in the first table. Click the slot number
of an active line card to open the following screen. Use this screen to set which of the line card’s
ports belong to the static multicast group.
Figure 118
Static Multicast Slot
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
New After you click Apply , entries display in the first table so you can edit them. Click New if you
want to configure a different static multicast group.
Cancel Click Cancel to begin configuring the screen again.
Modify Select a static multicast group’s radio button and click Modify to display the static multicast
group in the table above so you can edit it.
Delete Select a static multicast group’s radio button and click Delete to remove the static multicast
group.
VID This is the number of the VLAN that this static multicast group uses.
Group IP This is the static multicast IP address.
Port This section lists the VLAN membership setting of the ports on the management switch card.
An “F” indicates that the port is a permanent member of the static multicast group. An “X”
indicates that the port is forbidden (blocked) from joining the static multicast group. An “-”
indicates that the port is a normal member and can join the VLAN dynamically. See
Table
320 on page 593 for more on VLAN registration.
Slot This section displays the numbers of any slots that are fixed members of the static multicast
group. All other slots are represented by a “-”.
Select Select a static multicast group’s radio button and then click Modify to be able to edit it or
click Delete to remove it.
Table 79
Static Multicast (continued)
LABEL DESCRIPTION