Zeiss humphrey HFA II-i series, Руководство по обслуживанию на месте

Страница: 265 / 521

Humphrey Field Analyzer II - i Appendix C
Confidential and Proprietary
52235C1105 C - 5
Field Service Guide
C.4 HFA II To HFA II - i Serial Data Transfer
Transfer of serial data from the HFA II to HFA II - i is possible in both Serial I transfer mode
and Serial II transfer mode. However, you must have the HFA II - i and the HFA II set to the
Serial II transfer mode to ensure that all of the test information (SITA and gaze data) is passed
to the
HFA II - i .
Transmitting HFA II Tests to HFA II - i
1) Ensure that the Serial II Transfer Disk is loaded on the HFA II. Check the destination
window of the Transfer Files selection on the File Functions Menu. If not, load the Serial
II Transfer Disk as described in Appendix section C.2.
2) Ensure that the data transfer cable is connected between the HFA II - i DATA
TRANSFER port and the HFA II SERIAL PORT 1.
On the HFA II
3) From the Main Menu, select
System Setup
.
4) Select the
Save/Transmit
option.
5) Select
RS-232 Options
.
6) On the RS-232 Options screen, select the following settings:
A) Set Baud Rate to 9600
B) Parity to Even
C) Data Bits to 7
D) Stop Bits to 1
7) Press
Proceed
. The Transmit/Save screen will then appear.
8) Press the
Main Menu icon
in the upper right corner of the screen.
9) From the Main Menu, select
File Functions
.
10) Select
Transfer Tests
. A dialog box titled “Disk Options” will appear on screen.
11) Select
Hard Drive
as the Source.
12) Select
HFA II Serial Cable
as the Destination.
13) Select the
Directory Order
(either
Name
or
Date
), then press
Proceed
.
• If you chose
Name
:
To select all files on the drive, press
Enter
, and
Select All
. All files on the disk
will be marked with a “
9
” to indicate that they have been selected.