Zeiss humphrey HFA II-i series, Руководство по обслуживанию на месте

Страница: 448 / 521

Page 4 FA2i-025A
3. Select Security Code . A pop-up keypad will open to allow you to enter the Security Code
received on the Carl Zeiss Meditec website. Once you have entered the code, select Enter to
record the data and return to the License Registration screen.
4. Select Save to record the settings and to return to the Install Software screen. If you have
made a mistake entering the data, you will see the following dialogue:
One or more values entered are invalid. Please verify the values you
have entered and try again.
5. If you have successfully entering the data, you will see the following dialogue:
The software has been installed successfully.
6. Select the newly registered product Install button. Select Print to print out a copy of the
licensing settings for the customer. Tell the customer to save this information as it will be
required should the licensing information on the system need to be restored. Ask the
customer to staple or tape the printout inside of the HFA2i Owner’s Guide.
7. Select Done to complete the licensing process, or select the appropriate button to license
another software option.
8. After selecting Done , a message will be displayed “Please cycle power to restart.” Turn off
the HFA2i and wait approximately 10 seconds before turning it on again.
9. Create a new backup configuration disk.
10. This completes the Licensing process.
Removing the Licensed Feature
Situations may arise where the license must be removed from the system. Do not allow customers to
casually press the “Remove” button on the License Information screen without serious consideration of
the effects.
Note: Once an optional software product is removed, it cannot be licensed again with the
same product certificate number. Please contact Order Administration for assistance.
1. From the HFA2i instrument Main Menu, select System Setup.
2. Select Additional Setup .
3. Select Install Software.
4. Select the Install button for the appropriate feature you are going to remove.
5. Select the Remove button. The following dialogue will be displayed:
Warning
If you proceed, the feature, feature name , will no longer be available.
6. At this point, you may choose the Cancel or Proceed button. Proceed will allow you to
continue with the removal process. Cancel will halt the license removal process.
7. Select Proceed .
8. A dialogue will be displayed:
Feature name
Your Removal Code is XXXX/XXXX.
9. You will have two choices: Print and Cancel . Print will print the removal code and complete
the removal process. Cancel will complete the removal process without printing the code.
10. Provide the removal code to your Carl Zeiss order entry group. The removal code is used to
validate that the features have been removed. No customer credit will be given without the
removal code.