Zeiss humphrey HFA II-i series, Руководство по обслуживанию на месте

Страница: 288 / 521

Appendix G Humphrey Field Analyzer II - i
Confidential and Proprietary
Field Service Guide
G - 6 52235C1105
G.4 Setting the Software Options
NOTE: Setting the software options is required whenever the hardware option number has
been changed or the Cal/Config Data has just been initialized. Please note that the DST
cannot be used to set the software option number unless the instrument is being repaired at
the Carl Zeiss Meditec factory. All other repair situations must follow the procedure
described below.
The software option number is automatically created during the installation of application
software. The software option number is based on the hardware option number already
written into the Cal/Config Data. Ensure that the correct hardware option number has been
written to the Cal/Config Data prior to creating the software option number.
1) Ensure that you have the latest revision of application software.
2) Follow the procedures in Appendix M for loading the application software.
3) At the HFA II - i Main Menu, select the
“i”
button at the top of the screen. When the
HFA II - i Unit Configuration screen is displayed, verify that the correct Model Number,
Hardware Option Number and Software Option Number have been set, based on
instrument model (see Table G-1).
NOTE: The Hardware and Software Option Numbers are based on revision C3 software
residing on the hard disk.
Table G-1.
Model Number Hardware Option
Number
Software Option Number
720 i 000134 0011590C
740 i 230134 00157918
745 i 330134 0015f918
750 i b30334 0017F9F8