Toshiba e-Studio477s, Руководство по обслуживанию, Страница: 393 / 482

e-STUDIO477S/527S
05/08 Mode Element Sub Element Item Subitem Code
Sub-
Code
Details
Default
value
Acceptable
value
RAM Contents
Proc
edure
ServiceUI
08 E-mail address direct input
button
Switches the display setting of the [INPUT @]
button.
0: Not displayed
1: Displayed
Setting
mode
System User interface Display setting 8738 1 0~1 1 Yes SYS
08 Switchover of pop-up
display during scanning
Switches the pop-up display during scanning
0: Not displayed
1: Displayed
Setting
mode
System User interface Display setting 8744 1 0~1 1 SYS
08 Enable/Disable setting of
EWB history
Sets whether part of the cookie, password, and
form data of user who logs in to EWB is saved or
not.
0: Disabled
1: Enabled
Setting
mode
System User interface 8745 0 0~1 1 SYS
08 Port number setting of
destination 10 for sending
trap
Sets the port number of destination 10 for sending
SNMP trap. If the port is used when using the real
time log notification function, change the port
number.
Setting
mode
System Network 8746 162 1~65535 12 NIC
08 Input of department code at
user authentication
0: Not required
1: Required
Setting
mode
System User interface 8748 0 0~1 1 SYS
08 User authentication by
logon information to domain
(external authentication)
0: Disabled
1: Enabled
Setting
mode
System Network 8749 0 0~1 1 SYS
08 Time to wait for print image Sets whether the drum idling is executed or not
when the waiting for print image occurred. If there
is the stain on the back side of the paper, set the
value of this code to "1". When the value is set to
"1", the number of times the equipment stops
printing may increase.
0: Waiting is enabled (8 sec.)
1: Waiting is disabled (0 sec.)
Setting
mode
System General 8750 0 0~1 1 SYS
08 Switchover of display of
notice on the control panel
when the time to replace the
unit has come
Specifies the contents of the message displayed
on the control panel when the time to replace the
unit has come.
0: Contact the service engineer for replacement
1: Replacement by user
<Default value>
JPD/MJD: 0
Others: 1
Setting
mode
System Maintenance 8752 Refer to
contents
0~1 1 Yes SYS
08 Output of error sheet at
reception of PDL data not
supported
0: Disabled
1: Enabled
Setting
mode
System General 8754 1 0~1 1 SYS
08 Enable/Disable setting 0: Disabled
1: Enabled
Setting
mode
System Maintenance Notification of
remaining
amount of toner
8755 0 0~1 1 Yes SYS
08 Remaining amount at first
notification
0 to 100% Setting
mode
System Maintenance Notification of
remaining
amount of toner
8756 0 25 0~100 4 Yes SYS
08 Notification interval 1 to 25% Setting
mode
System Maintenance Notification of
remaining
amount of toner
8756 1 10 1~25 4 Yes SYS
40 Ver03 08 Setting Mode