Rohde & Schwarz CMU-K20, Руководство по эксплуатации

Страница: 494 / 646

Connection Control (Signalling only) CMU-K20/21/22/23/24
1115.6088.12 6.190 E-12
CONFigure:BSSignal[:CSWitched][:TCH]:MSLot:MTIMeslot <Slot_No>
Main Timeslot
<Slot_No>
Description of parameters Def. value Def. unit FW vers.
0 to 7
Main timeslot, used for signalling 3 – V3.05
Description of command Sig. State
This command defines the timeslot that the MS and the BS/CMU use for signalling (default value).
Changing the main timeslot also overwrites the
Meas.- Slot
(command
CONFigure:MCONtrol:MSLot:MESLot
). If used in the CEST state, this command overwrites the
main timeslot set via
PROCedure:SIGNalling[:CSWitched][:TCH]:MSLot:SCONfig
(see p.
6.181 ).
≠
CEST,
Q: all
CONFigure:BSSignal[:CSWitched][:TCH]:MSLot:LMODe <Mode>
Level Mode
<Slot_No>
Description of parameters Def. value Def. unit FW vers.
UUN |
IND
Used timeslot and unused timeslot levels
Individual timeslot levels UUN – V3.05
Description of command Sig. State
This command determines whether the CMU uses the used/unused timeslot level scheme (two
different levels) or individual levels in all timeslots.
≠
CEST,
Q: all
CONFigure:BSSignal[:CSWitched][:TCH]:MSLot:SCONfig:UUNused
Slot Configuration: Used/Unused
<Enable_0>,<Enable_1>, ..., <Enable_7>
<Enable_n>
Description of parameters Def. value Def. unit FW vers.
ON | OFF
Enable or disable timeslot no. n see below – V3.05
Description of command Sig. State
This command defines the active timeslots slots of the BS signal (default values) and implicitly
defines the levels for the
Used/Unused
level mode (see command
CONFigure:BSSignal[:CSWitched][:TCH]:MSLot:LMODe
on p. 6.190 ).
•
The level in all enabled timeslots is given by the
Used Timeslot Level
defined via
CONFigure:BSSignal[:CSWitched][:TCH]:LEVel:UNTimeslot
(see p. 6.188 ).
•
The level in all disabled timeslots is given by the
Unused Timeslot Level
def. via
CONFigure:BSSignal[:CSWitched][:TCH]:LEVel:UTIMeslot
(see p. 6.187 ).
In the default setting, timeslots 3 and 4 are enabled. By default, slot no. 3 is also the main timeslot;
see command
CONFigure:BSSignal[:CSWitched][:TCH]:MSLot:MTIMeslot
on p. 6.190 .
Note:
The <Enable_n> parameters also apply in individual level mode; they overwrite the
parameters in the
CONFigure:BSSignal[:CSWitched][:TCH]:MSLot:SCONfig:INDividual
command.
≠
CEST,
Q: all
深圳德标仪器
135-1095-0799