Rohde & Schwarz CMU-K20, Руководство по эксплуатации

Страница: 340 / 646

Common: WPOWer CMU-K20/21/22/23/24
1115.6088.12 6.36 E-12
CONFigure:WPOWer:EREPorting < Mode > Event Reporting
<Mode> Description of parameters Def. value Def. unit FW vers.
SRQ |
SOPC |
SRSQ |
OFF Service request
Single operation complete
SRQ and SOPC
No reporting
OFF – 1.17
Description of command
This command defines the events generated when the measurement is terminated or stopped (event reporting,
see chapter 5 of CMU200 operating manual).
FETCh:WPOWer:STATus? Measurement
Return Description of parameters Def. value Def. unit FW vers.
OFF |
RUN |
STOP |
ERR |
STEP |
RDY,
1 ... 10000 |
NONE Measurement in the OFF state (
*RST
or
ABORt
)
Running (after
INITiate, CONTinue
or
READ
)
Stopped (
STOP
)
OFF (could not be started)
Stepping mode (<stepmode>=STEP)
Stopped according to repetition mode and stop condition
Counter for current statistics cycle
No counting mode set
OFF
NONE –
– 1.15
Description of command
This command is always a query. It returns the status of the measurement (see chapters 3 and 5 of CMU
operating manual).
CONFigure:WPOWer:CONTrol:REPetition < Repetition > ,<StopCond>,<Stepmode> Test cycles
<Repetition> Description of parameters Def. value Def. unit
CONTinuous |
SINGleshot |
1 ... 10000 Continuous measurement (until
STOP
or
ABORT)
Single shot measurement (until
Status = RDY
)
Multiple measurement
(
counting , until
Status = STEP | RDY)
SING
–
<StopCond> Description of parameters Def. value Def. unit
SONerror |
NONE Start measurement in case of error (stop on error)
Continue measurement even in case of error
NONE –
<Stepmode> Description of parameters Def. value Def. unit FW vers.
STEP |
NONE Interrupt measurement after each statistics cycle
Continue measurement according to its rep. mode NONE – 1.15
Description of command
This command determines the number of statistics cycles, the stop condition and the stepping mode for the
measurement.
Note: In the case of READ commands (
READ:
...), the <Repetition> parameter has no effect; the
measurement is always stopped after a single shot.
深圳德标仪器
135-1095-0799