Rohde & Schwarz CMU-K20, Руководство по эксплуатации

Страница: 449 / 646

CMU-K20/21/22/23/24 Signalling: POWer:PCL
1115.6088.12 6.145 E-12
Scalar Results
READ[:SCALar]:POWer:PCL:PCLPower<PCL>? Start single shot measurement and return results
FETCh[:SCALar]:POWer:PCL:PCLPower<PCL>? Read out measurement results (unsynchronized)
SAMPle[:SCALar]:POWer:PCL:PCLPower<PCL>? Read out measurement results (synchronized)
Returned Value Value range Def. value Def. unit FW vers.
PCh1, ... , P1Chn See previous command NAN dBm V2.15
Description of command
These commands are always queries. They start a measurement and return the mobile output power at one
particular PCL specified with the numeric index <PCL> and for the channels specified via
CONFigure:POWer:PCL:CHANnel.
The total number n of channels measured is either 3 or 7, depending on
the
CONFigure:POWer:PCL:CCOunt
setting. See also command description for
READ[:SCALar]:POWer:PCL[:CURRent]?
CALCulate:POWer:PCL[:CURRent]:LIMit:MATChing? Results of Limit Check
Returned values Description of parameters Def. value Def. unit FW vers.
Matching OK | NMAU | NMAL | INV INV – VV2.00
Description of command
This command is always a query. It indicates whether and in which way the tolerances for the burst power (see
preceding command) are exceeded. The tolerance values are set via
CONF:POW:LIM:ABP<nr>
.
The following messages may be output for the measured value Matching :
OK Tolerance value matched OK.
NMAU Underflow of tolerance value not matching, underflow
NMAL Tolerance value exceeded not matching, overflow
INV Measured value invalid invalid
The complete output list reports the limit matching for all measured PCLs and the three or seven channels
defined via
CONFigure:POWer:PCL:CHANnel,
starting with the channels for the first PCL, e.g. (for three
channels):
1, OK, OK, OK, 2, OK, OK, OK, 3, OK, OK, OK, ...
深圳德标仪器
135-1095-0799