Rohde & Schwarz CMU-K20, Руководство по эксплуатации

Страница: 231 / 646

CMU-K20/K21/K22/K23/K24
Signalling: Connection Control
1115.6088.12 4.153 E-12
Fig. 4-69 Connection Control – Handover (Call Pending)
Destination
Parameter
The
Destination Parameter
softkey sets important target network parameters that
come into effect as soon as the call is handed over.
Default All Sett.
Sets all
Destination Parameters
to default values.
RF Channel
Traffic channel number used for the connection in the target
network.
Note: The channel numbers in GSM1800 and GSM1900 are ambiguous. To
ensure that the RF Channel is correctly interpreted check the setting
of the
Band Indicator
(see p.
4.178
)
.
For a handover between
GSM1800 and GSM1900 the
Band Indicator
should be changed
before the handover is initiated.
The following additional parameters can be set if circuit switched main service is
active (see section
Signalling Control without Signal (State Signal Off)
on p. 4.90
ff.):
Starting Time
Time interval (in frames) after which the mobile station performs
a new registration with the base station after a channel,
timeslot, and fast power change.
PCL (MS)
Power control level used by the mobile station to call and
perform a location update in the target network.
The following additional parameters can be set if packet data main service is
active (see section
Signalling Control without Signal (State Signal Off)
on p. 4.90
ff.):
Coding Scheme
GPRS coding schemes for traffic data channels, CS1 to CS4;
modulation and coding schemes MCS1 to MCS9 for EGPRS
See also section
Network Parameters (Connection Control – Network)
on page
4.169 ff.
Remote control
CONFigure:NETWork[:CSWitched]:SMODe:STIMe DEF
CONFigure:MSSignal[:CSWitched][:TCH][:SSLot]MS:PCL DEF
CONFigure:BSSignal[:CSWitched][:TCH]:CHANnel DEF
CONFigure:NETWork[:CSWitched]:SMODe:STIMe <Frames>
CONFigure:MSSignal[:CSWitched][:TCH][:SSLot]MS:PCL <PCL>
深圳德标仪器
135-1095-0799