Rohde & Schwarz CMU-K20, Руководство по эксплуатации

Страница: 451 / 646

CMU-K20/21/22/23/24 Signalling: POWer:MPR
1115.6088.12 6.147 E-12
Subsystem POWer:MPR:CONTrol
The subsystem POWer:MPR:CONTrol defines the repetition mode, statistic count, and stop condition of
the measurement.
CONFigure:POWer[:NORMal][:GMSK]:MPR:CONTrol < Mode>, <Statistics >
Scope of Measurement
<Mode> Desciption of parameters Def. value Def. unit
SCALar |
ARRay Scalar values only (incl. ramp matching)
Scalar measured values and arrays ARRay –
<Statistics> Description of parameters Def. value Def. unit FW vers.
1 to 1000 |
NONE Number of bursts per statistics cycle
Statistics off (equivalent to 1) 100 – V2.00
Description of command
This command specifies the type of measured values and defines the number of bursts forming a statistics cycle.
CONFigure:POWer[:NORMal][:GMSK]:MPR:CONTrol:REPetition Test Cycles
< Repetition > ,<StopCond>,<Stepmode>
<Repetition> Description of parameters Def. value Def. unit
CONTinuous |
SINGleshot |
1 to 10000 Continuous measurement (until
STOP
or
ABORT)
Single shot measurement (until
Status = RDY
)
Multiple measurement
(
counting , until
Status = STEP | RDY)
SING –
<StopCond> Description of parameters Def. value Def. unit
SONerror |
NONE Stop measurement in case of error (stop on error)
Continue measurement even in case of error
NONE –
<Stepmode> Description of parameters Def. value Def. unit FW vers.
STEP |
NONE Interrupt measurement after each statistics cycle
Continue measurement according to its rep. mode NONE – V2.00
Description of command
This command determines the number of statistics cycles, the stop condition and the stepping mode for the
measurement.
Note: In the case of READ commands (
READ:
...), the <Repetition> parameter has no effect; the
measurement is always stopped after a single shot.
深圳德标仪器
135-1095-0799