Rohde & Schwarz CMU-K20, Руководство по эксплуатации

Страница: 317 / 646

CMU-K20/K21/K22/K23/K24
Measurement Groups (Non Signalling only)
1115.6088.12 6.13 E-12
CONFigure:POWer[:NORMal][:GMSK]:CONTrol < Mode>, <Statistics > Scope of Measurement
CONFigure:POWer[:NORMal]:EPSK:CONTrol < Mode>, <Statistics >
<Mode> Desciption of parameters Def. value Def. unit
SCALar |
ARRay Scalar values only (incl. ramp matching)
Scalar measured values and arrays ARRay –
<Statistics> Description of parameters Def. value Def. unit FW vers.
1 to 1000 |
NONE Number of bursts per statistics cycle
Statistics off (equivalent to 1) 100 – V1.15
Description of command
This command specifies the type of measured values and defines the number of bursts forming a statistics cycle.
CONFigure:POWer[:NORMal][:GMSK]:CONTrol:REPetition
CONFigure:POWer[:NORMal]:EPSK:CONTrol:REPetition
< Repetition > ,<StopCond>,<Stepmode> Test cycles
<Repetition> Description of parameters Def. value Def. unit
CONTinuous |
SINGleshot |
1 to 10000, Continuous measurement (until
STOP
or
ABORT)
Single shot measurement (until
Status = RDY
)
Multiple measurement
(
counting , until
Status = STEP | RDY)
SING –
<StopCond> Description of parameters Def. value Def. unit FW vers.
SONerror |
NONE, Stop measurement in case of error (stop on error)
Continue measurement even in case of error
NONE – V1.15
<Stepmode> Description of parameters Def. value Def. unit
STEP |
NONE Interrupt measurement after each statistics cycle
Continue measurement according to its rep. mode NONE –
Description of command
This command determines the number of statistics cycles, the stop condition and the stepping mode for the
measurement.
Note: In the case of READ commands (
READ:
...), the <Repetition> parameter has no effect; the measure-
ment is always stopped after a single shot.
DISPlay:POWer[:NORMal][:GMSK]:CONTrol:GRID <Enable> Grid
DISPlay:POWer[:NORMal]:EPSK:CONTrol:GRID <Enable>
<Enable> Description of parameters Def. value Def. unit FW vers.
ON |
OFF Switch on the grid lines
Switch off the grid lines ON – V1.15
Description of command
This command switches the grid lines in the test diagram on or off.
深圳德标仪器
135-1095-0799