Rohde & Schwarz 1332.4500.22, Руководство пользователя

Страница: 525 / 1476

GUI Reference
R&S
®
ZNA
525 User Manual 1178.6462.02 ─ 12
Input/Output Tab
This tab gives access the settings for the optional Direct Generator/Receiver Access
and Chapter 5.7.20, "Direct IF Access" , on page 225.
If a port is configured as converter port, all its "Input / Output" settings are derived from
the settings in the
Converter Configuration Dialog . Hence the corresponding table row
is read-only.
Background information
Refer to Chapter 5.7.17, "Direct Generator/Receiver Access" , on page 224 and Chap-
ter 5.7.20, "Direct IF Access" , on page 225.
Receiver Input
Determines how the MEAS and REF signals are routed to the respective receivers.
Depending on the selected path, the hardware and factory correction values are set. If
"Port" is used, also the factory calibration is applied. This setting ensures reasonably
corrected data with the different cabling options.
"Port" Via the standard port and with standard jumpering of the Direct Gen-
erator/Receiver Access connectors.
"Direct
Access" Via the direct generator/receiver access connectors (see Chap-
ter 5.7.17, "Direct Generator/Receiver Access" , on page 224).
"Reverse Cou-
pler" Via the standard port but with reversed coupler configuration (see
"Reverse Coupler Configuration" on page 224).
"Source Moni-
tor" Via the direct source monitor access connector (see Chapter 5.7.24,
"Direct Source Monitor Access" , on page 227).
Can only be selected for analyzer ports 1 and 3, and only if the
optional source monitor access is available for this port.
"Rear IN" Via the direct IF access connectors (see Chapter 5.7.20, "Direct IF
Access" , on page 225).
For "Direct Access", "Reverse Coupler", and "Source Monitor" access, the LED above
the direct generator/receiver access connectors is switched on
For analyzer ports that are used as converter ports, the "Receiver Input" is configured
in the
Converter Configuration Dialog .
Channel Config Softtool