Rohde & Schwarz 1332.4500.22, Руководство пользователя

Страница: 258 / 1476

GUI Reference
R&S
®
ZNA
258 User Manual 1178.6462.02 ─ 12
●
"b1 Source Port 2" is the wave received at physical port 1. In a standard S-parame-
ter measurement, this wave is transmitted at port 2 of the DUT (reverse measure-
ment).
●
"b2 Source Port 2" is the wave received at physical port 2. In a standard S-parame-
ter measurement, this wave is fed to the output port (port 2) of the DUT (reverse
measurement).
Tip: In the trace list, the source port is indicated in brackets. For example, "a1(P1)"
denotes the wave a
1
with source port 1.
The analyzer can also measure arbitrary wave quantities for other source ports; see
Chapter 6.2.3.2, "More Wave Quantities Dialog" , on page 258.
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "A1" | ...
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "A1" | ...
Wave Correction
Determines whether wave quantities and ratios are system error corrected in the active
channel.
If checked (default), the "best available" calibration is applied, with the following prece-
dence:
●
Scalar power calibration
●
User system error correction
●
Factory system error correction
Note:
●
Only a single calibration is applied.
●
If "Wave Correction" is turned off, no calibration is applied for these measurement
quantities at all.
Remote command:
[SENSe<Ch>:]CORRection:EWAVe[:STATe]
6.2.3.2 More Wave Quantities Dialog
The "More Wave Quantities" dialog provides arbitrary wave quantities with arbitrary
source ports as measured quantities. All wave quantities can be calculated with differ-
ent detector settings.
Access: Trace – [Meas] > "Wave" > "More Wave Quantities..."
Background information
Refer to the following sections:
●
Chapter 5.3.5.1, "Wave Quantities" , on page 110
●
Chapter 5.3.5.2, "Ratios" , on page 111
Meas Softtool