PiXtend V2 -L- Hardware Manual
If the Raspberry Pi computer has already been screwed onto your PiXtend V2 -L-, the four
screws must be loosened again
2
. If necessary, disconnect already connected cables from
your PiXtend system (PiXtend & Raspberry Pi).
The Raspberry Pi can be lifted off the spacers, the flat ribbon cable remains connected:
The stainless steel housing consists of two parts. The large, lower part of the hood is
twisted so that it can be guided over the Raspberry Pi and placed on the six spacers on
the PiXtend V2 -L- board (Figure 20).
The second, small hood part is attached over the Raspberry Pi later.
2
If the Raspberry Pi has not yet been connected / installed, please observe the explanations for the
connection of the flat ribbon cable on page 22.
www.pixtend.com
Copyright by Qube Solutions GmbH
34 / 146
Figure 19: Raspberry Pi lifted from PiXtend
(flat ribbon cable remains connected)
