PiXtend V2 -L- Hardware Manual
Before inserting the circuit board, take a look at the locking element. This marks the later
bottom (if the housing is installed horizontally).
The outside dimensions of the printed circuit board were specially designed for these
housings. It is intended that the circuit board is very tightly seated in the housing.
If the module is completely inserted, the second side part can be mounted and fixed with
the remaining two screws. Do not be surprised at the fact that the board is still slightly
beyond the profile. This small overhang is covered by the side part.
The PiXtend V2 -L- module now looks as follows:
In a control cabinet or control box, where hazardous voltages are also used, it is
necessary that all accessible metal parts are grounded (connected to PE). This includes
the PiXtend V2 -L- DIN rail housing.
www.pixtend.com
Copyright by Qube Solutions GmbH
30 / 146
Figure 14: DIN rail housing assembled
Figure 15: DIN rail housing assembled - back
