PiXtend V2 -L- Hardware Manual
5. Startup
This chapter describes step by step all points to start up your PiXtend V2 -L-. Please read
the entire chapter first and observe the relevant connection notes in chapter 6
Technical
Data & Connection Notes
before you work with your PiXtend V2 -L- system.
See chapter 5.1 for information on jumpers and switches on PiXtend V2 -L-. You can
configure your PiXtend V2 board with just a few simple steps.
Then you create an SD card from one of the provided SD card images with the "Basic
Image” (C / Python / Node-RED / OpenPLC) or "CODESYS Control Demo" for your
Raspberry Pi.
If you have a PiXtend V2 -L- Extension Board - without Raspberry Pi -, a separately
purchased Raspberry Pi must be installed before the first start. The assembly instructions
can be found from page 22 in this document.
After the preparatory work, your PiXtend V2 -L- system is ready to start and can be
connected to a suitable power supply. Here we give you important tips for the correct and
secure connection.
www.pixtend.com
Copyright by Qube Solutions GmbH
42 / 146
