Nortel Modular ICS 7.1, Инструкция по установке

Страница: 654 / 700

654 / Glossary
Modular ICS 7.1 Installer Guide N0130943 02
ring group:
A setting under Services
that allows you to assign a number of
different telephones to ring during one
of the schedules.Up to 20 ring groups
can be programmed by an installer or a
system coordinator plus.
ring type:
≤•fl
A feature that allows you to select one of
four distinctive rings for your telephone.
ring volume:
≤•°‚
A feature that allows you to set the
volume at which your telephone rings.
ringing service: A Services section
that allows you to make additional
telephones ring at specified times of the
day and on specified days.
Rls button:
Ends a call in the same
way that hanging up the receiver does.
The Release button may also be used to
end programming, Maintenance
sessions, and feature operations.
Routing:
See Routing service.
Routing service:
A programming
section that allows outgoing calls to be
directed automatically based on the
numbers a caller dials. For Norstar
systems linked in a network, routing can
create a transparent or coordinated
dialing plan. It can also be used to direct
calls to the least expensive lines
according to a Services schedule
(sometimes called least cost routing).
Run/Stop:
≤•·
A feature that creates a break point in a
programmed external dialing sequence.
When you press a programmed key, the
system dials the number up to the run/
stop. When you press it again, the
system dials the digits following the run/
stop.
S
S loop: A type of loop provided by a
BRI-ST Card. It connects the ICS to
ISDN terminal equipment which uses an
S interface.
SAPS:
See station auxiliary power
supply.
Saved Number Redial:
≤fl‡
A feature that allows you to save the
number of the external call you are on
(providing you dialed the call) so that
you can call it again later.
Schedules:
Any of six different sets
of services that can be applied to your
Norstar system. A schedule can be
activated manually from a control
telephone or activated automatically at
specified times. See also Services.
Selective line redirection: See Line
Redirection.
Service modes See Services.
Service Profile Identifier: See
SPID.
Services:
A programming section
that allows you to assign which
telephones ring, which restrictions
apply, and which call routing is used
during any of six different schedules.
There are three services: Ringing
service, Restriction service and Routing
service, all found in Services
programming.
set:
A telephone.
Set Copy: A programming section
that allows you to copy programmable
settings from one telephone to another
of the same type. Set Copy provides two
options: duplicating System Data and
User Data, or duplicating System Data
only. Set Copy does not provide the
same copy capability as
COPY
, which is
more selective of the settings that can be
duplicated.