Nortel Modular ICS 7.1, Инструкция по установке, Страница: 624 / 700

624
/ Problems for network or remote users
Modular ICS 7.1 Installer Guide N0130943 02
3. Check that you have defined the correct Auto DN for your
system.
4. Make sure that the published telephone numbers for your
network are correct.
Dialed number gets busy tone
Possible problem
The target line that the incoming digits map onto is busy, and
there is no prime telephone for the incoming trunk.
Solution
For maximum call coverage, make sure that you configure a
prime telephone for every incoming trunk.
Dialed number does not get through
Possible problem
The digits sent by a switch at a central office or in the private
network did not match any Received number, the Auto DN, or
the DISA DN. There is also no prime telephone assigned for
the incoming trunk. In this case, the caller may hear overflow
tone from the Norstar system or a recorded message from the
originating switch.
Solution
1. Configure a prime telephone for every incoming trunk.
2. Verify that the switch is sending the correct number of
digits for the Received number length defined in your
system.
3. Verify all the digit strings that the switch should be
sending.