Nortel Modular ICS 7.1, Инструкция по установке

Страница: 563 / 700

Provisioning BRI and PRI lines /
563
N0130943 02 Modular ICS 7.1 Installer Guide
Provisioning BRI and PRI lines
This section discusses how you put BRI and PRI lines into and
out of service.
BRI and T1 lines
Installer password required
Provisioning applies to BRI and T1 loops and lines. It allows
you to place loops and lines in or out of service, either before
or after the BRI Cards have been installed in the ICS.
When you provision a loop, ISDN terminals on the loop can be
used to make outgoing calls or receive incoming calls
(S or U-LT loop).
Loop lines are also available for use by the devices attached to
the system (T, S, or U-NT loop). When you are configuring a
T, S, or NT loop, you must also provision each line on the loop
to place the lines in service.
Cd1-ICS
The card type will appear with the setting. If no card has been
installed, you can change the card type under
Hardware
.
1. Press
≠
to display the loops found on the card.
2. Press
REMOVE
to take the loop out of service.
3. If lines on the loop are busy, the display will ask if you still
want to remove the loop from service.
Press
YES
to go ahead.