Kontron CP6923, Справочное руководство, Страница: 43 / 480

CP6923 Using the Command-Line Interface
Page 1 - 9 CP6923 CLI Reference Manual
parms Configure Network Parameters of the router.
protocol Select DHCP, BootP, or None as the network config
protocol.
If the help output shows a parameter in angle brackets, you must replace the parameter with a value.
(switch) #network parms ?
<ipaddr> Enter the IP address.
If there are no additional command keywords or parameters, or if additional parameters are optional, the following
message appears in the output:
<cr> Press Enter to execute the command
You can also enter a question mark (?) after typing one or more characters of a word to list the available command
or parameters that begin with the letters, as shown in the following example:
(switch) #show m?
mac-addr-table mac-address-table monitor
1.12 Accessing the CLI
You can access the CLI by using a direct console connection or by using a telnet or SSH connection from a remote
management host.
For the initial connection, you must use a direct connection to the console port. You cannot access the system
remotely until the system has an IP address, subnet mask, and default gateway. You can set the network
configuration information manually, or you can configure the system to accept these settings from a BOOTP or
DHCP server on your network. For more information, see 7.1 “Network Interface Commands” on page 7 - 2.