Kontron CP6923, Справочное руководство, Страница: 390 / 480

Management Commands CP6923
CP6923 CLI Reference Manual Page 7 - 4
7.1.7 network mac-type
This command specifies whether the switch uses the burned in MAC address or the locally-administered MAC
address.
7.1.7.1 no network mac-type
This command resets the value of MAC address to its default.
7.1.8 show network
This command displays configuration settings associated with the switch's network interface. The network interface
is the logical interface used for in-band connectivity with the switch via any of the switch's front panel ports. The
configuration parameters associated with the switch's network interface do not affect the configuration of the front
panel ports through which traffic is switched or routed.
Default burnedin
Format
network mac-type {local | burnedin}
Mode Privileged EXEC
Format
no network mac-type
Mode Privileged EXEC
Format
show network
Modes • Privileged EXEC
• User EXEC
Term Definition
IP Address The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6
Administrative
Mode
Whether enabled or disabled.
IPv6 Address/
Length
The IPv6 address and length.
IPv6 Default
Router
The IPv6 default router address.
Burned In MAC
Address
The burned in MAC address used for in-band connectivity.
Locally
Administered MAC
Address
If desired, a locally administered MAC address can be configured for in-band connectivity. To
take effect, 'MAC Address Type' must be set to 'Locally Administered'. Enter the address as
twelve hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be
set to a 1 and bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. The MAC
address used by this bridge when it must be referred to in a unique fashion. It is recommended
that this be the numerically smallest MAC address of all ports that belong to this bridge.
However it is only required to be unique. When concatenated with dot1dStpPriority a unique
BridgeIdentifier is formed which is used in the Spanning Tree Protocol.
MAC Address Type The MAC address which should be used for in-band connectivity. The choices are the burned
in or the Locally Administered address. The factory default is to use the burned in MAC
address.