Kontron CP6923, Справочное руководство, Страница: 221 / 480

CP6923 Routing Commands
Page 4 - 9 CP6923 CLI Reference Manual
4.2.5 ip route default
This command configures the default route. The value for
<nexthopip>
is a valid IP address of the next hop router.
The
<preference>
is an integer value from 1 to 255. A route with a preference of 255 cannot be used to forward
traffic.
4.2.5.1 no ip route default
This command deletes all configured default routes. If the optional <nexthopip> parameter is designated, the
specific next hop is deleted from the configured default route and if the optional preference value is designated, the
preference of the configured default route is reset to its default.
4.2.6 ip route distance
This command sets the default distance (preference) for static routes. Lower route distance values are preferred
when determining the best route. The
ip route
and
ip route default
commands allow you to optionally set
the distance (preference) of an individual static route. The default distance is used when no distance is specified in
these commands. Changing the default distance does not update the distance of existing static routes, even if they
were assigned the original default distance. The new default distance will only be applied to static routes created
after invoking the
ip route distance
command.
4.2.6.1 no ip route distance
This command sets the default static route preference value in the router. Lower route preference values are
preferred when determining the best route.
4.2.7 ip netdirbcast
This command enables the forwarding of network-directed broadcasts. When enabled, network directed broadcasts
are forwarded. When disabled they are dropped.
Default preference—1
Format ip route default <nexthopip> [<preference>]
Mode Global Config
Format
no ip route default [{<nexthopip> | <preference>}]
Mode Global Config
Default 1
Format
ip route distance <1-255>
Mode Global Config
Format no ip route distance
Mode Global Config
Default disabled
Format
ip netdirbcast
Mode Interface Config