Kontron CP6923, Справочное руководство, Страница: 253 / 480

CP6923 Routing Commands
Page 4 - 41 CP6923 CLI Reference Manual
4.8.37 ip ospf authentication
This command sets the OSPF Authentication Type and Key for the specified interface. The value of
< type >
is either
none, simple or encrypt. The <
key
> is composed of standard displayable, non-control keystrokes from a Standard
101/102-key keyboard. The authentication key must be 8 bytes or less if the authentication type is simple. If the type
is encrypt, the key may be up to 16 bytes. If the type is encrypt a
< keyid >
in the range of 0 and 255 must be
specified. Unauthenticated interfaces do not need an authentication key or authentication key ID. There is no default
value for this command.
4.8.37.1 no ip ospf authentication
This command sets the default OSPF Authentication Type for the specified interface.
4.8.38 ip ospf cost
This command configures the cost on an OSPF interface. The
< cost >
parameter has a range of 1 to 65535.
4.8.38.1 no ip ospf cost
This command configures the default cost on an OSPF interface.
4.8.39 ip ospf dead-interval
This command sets the OSPF dead interval for the specified interface. The value for
< seconds >
is a valid positive
integer, which represents the length of time in seconds that a router's Hello packets have not been seen before its
neighbor routers declare that the router is down. The value for the length of time must be the same for all routers
attached to a common network. This value should be some multiple of the Hello Interval (i.e. 4). Valid values range
in seconds from 1 to 2147483647.
Format
ip ospf authentication {none | {simple <key>} | {encrypt <key> <keyid>}}
Mode Interface Config
Format
no ip ospf authentication
Mode Interface Config
Default 10
Format
ip ospf cost < 1-65535>
Mode Interface Config
Format
no ip ospf cost
Mode Interface Config
Note: Effective with FASTPATH 4.4.4 and later, valid values range in seconds from 1 to 65535.
Default 40
Format
ip ospf dead-interval <seconds>
Mode Interface Config