Kontron CP6923, Справочное руководство, Страница: 151 / 480

CP6923 Switching Commands
Page 2 - 107 CP6923 CLI Reference Manual
2.21.1 set mld querier
Use this command to enable MLD Snooping Querier on the system (Global Config Mode) or on a VLAN. Using this
command, you can specify the IP address that the snooping querier switch should use as a source address while
generating periodic queries.
If a VLAN has MLD Snooping Querier enabled and MLD Snooping is operationally disabled on it, MLD Snooping
Querier functionality is disabled on that VLAN. MLD Snooping functionality is re-enabled if MLD Snooping is
operational on the VLAN.
The MLD Snooping Querier sends periodic general queries on the VLAN to solicit membership reports.
2.21.1.1 no set mld querier
Use this command to disable MLD Snooping Querier on the system. Use the optional parameter
address
to reset
the querier address.
2.21.2 set mld querier query_interval
Use this command to set the MLD Querier Query Interval time. It is the amount of time in seconds that the switch
waits before sending another general query.
2.21.2.1 no set mld querier query_interval
Use this command to set the MLD Querier Query Interval time to its default value.
2.21.3 set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period. It is the time period that the switch remains in
Non-Querier mode once it has discovered that there is a Multicast Querier in the network.
Default disabled
Format
set mld querier [ < vlan-id > ] [ address ipv6_address ]
Mode • Global Config
• VLAN Mode
Format
no set mld querier [< vlan-id >][ address ]
Mode • Global Config
• VLAN Mode
Default disabled
Format
set mld querier query_interval <1-18000>
Mode Global Config
Format
no set mld querier query_interval
Mode Global Config
Default 60 seconds
Format
set mld querier timer expiry <60-300>
Mode Global Config