Kontron CP6923, Справочное руководство, Страница: 249 / 480

CP6923 Routing Commands
Page 4 - 37 CP6923 CLI Reference Manual
4.8.22.1 no auto-cost reference-bandwidth (OSPF)
Use this command to set the reference bandwidth to the default value.
4.8.23 bandwidth
By default, OSPF computes the link cost of an interface as the ratio of the reference bandwidth to the interface
bandwidth. Reference bandwidth is specified with the
auto-cost
command. For the purpose of the OSPF link cost
calculation, use the bandwidth command to specify the interface bandwidth. The bandwidth is specified in kilobits
per second. If no bandwidth is configured, the bandwidth defaults to the actual interface bandwidth for port-based
routing interfaces and to 10 Mbps for VLAN routing interfaces. This command does not affect the actual speed of
an interface.
4.8.23.1 no bandwidth
Use this command to set the interface bandwidth to its default value.
4.8.24 capability opaque
Use this command to enable Opaque Capability on the Router. The information contained in Opaque LSAs may be
used directly by OSPF or indirectly by an application wishing to distribute information throughout the OSPF domain.
FASTPATH supports the storing and flooding of Opaque LSAs of different scopes.
4.8.24.1 no capability opaque
Use this command to disable opaque capability on the router.
4.8.25 clear ip ospf
Use this command to disable and re-enable OSPF.
Mode Router OSPF Config
Format
no auto-cost reference-bandwidth
Mode Router OSPF Config
Default actual interface bandwidth
Format
bandwidth < 1-10000000 >
Mode Interface Config
Format no bandwidth
Mode Interface Config
Default disabled
Format
capability opaque
Mode Router Config
Format
no capability opaque
Mode Router Config