Kontron CP6923, Справочное руководство, Страница: 397 / 480

CP6923 Management Commands
Page 7 - 11 CP6923 CLI Reference Manual
7.4 Secure Shell (SSH) Commands
This section describes the commands you use to configure SSH access to the switch. Use SSH to access the switch
from a remote management host.
7.4.1 ip ssh
Use this command to enable SSH access to the system. (This command is the short form of the
ip ssh server
enable
command.)
7.4.2 ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1), SSH2 (2), or both
SSH 1 and SSH 2 (1 and 2) can be set.
7.4.3 ip ssh server enable
This command enables the IP secure shell server.
7.4.3.1 no ip ssh server enable
This command disables the IP secure shell server.
Term Definition
Remote
Connection Login
Timeout (minutes)
This object indicates the number of minutes a remote connection session is allowed to remain
inactive before being logged off. May be specified as a number from 1 to 160. The factory
default is 5.
Maximum Number
of Remote
Connection
Sessions
This object indicates the number of simultaneous remote connection sessions allowed. The
factory default is 5.
Allow New Telnet
Sessions
New Telnet sessions will not be allowed when this field is set to no. The factory default value
is yes.
Note: The system allows a maximum of 5 SSH sessions.
Default disabled
Format
ip ssh
Mode Privileged EXEC
Default 1 and 2
Format
ip ssh protocol [1] [2]
Mode Privileged EXEC
Default disabled
Format ip ssh server enable
Mode Privileged EXEC
Format
no ip ssh server enable