Kontron CP6923, Справочное руководство, Страница: 286 / 480

Multicast Commands CP6923
CP6923 CLI Reference Manual Page 5 - 2
5. Multicast Commands
his chapter describes the IP Multicast commands available in the FASTPATH CLI.
The IP Multicast Commands chapter contains the following sections:
• 5.1 “Multicast Commands” on page 5 - 2
• 5.2 “DVMRP Commands” on page 5 - 6
• 5.3 “PIM-DM Commands” on page 5 - 10
• 5.4 “PIM-SM Commands” on page 5 - 12
• 5.5 “Internet Group Message Protocol (IGMP) Commands” on page 5 - 19
• 5.6 “IGMP Proxy Commands” on page 5 - 25
5.1 Multicast Commands
This section describes the commands you use to configure IP Multicast and to view IP Multicast settings and
statistics.
5.1.1 ip mcast boundary
This command adds an administrative scope multicast boundary specified by
< groupipaddr >
and
< mask >
for
which this multicast administrative boundary is applicable.
< groupipaddr >
is a group IP address and
< mask >
is
a group IP mask.
5.1.1.1 no ip mcast boundary
This command deletes an administrative scope multicast boundary specified by
< groupipaddr >
and
< mask >
for
which this multicast administrative boundary is applicable.
< groupipaddr >
is a group IP address and
< mask >
is
a group IP mask.
5.1.2 ip multicast
This command sets the administrative mode of the IP multicast forwarder in the router to active.
Caution! The commands in this chapter are in one of two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every configuration
command, there is a show command that displays the configuration setting.
Format
ip mcast boundary <groupipaddr> <mask>
Mode Interface Config
Format no ip mcast boundary <groupipaddr> <mask>
Mode Interface Config
Default disabled
Format
ip multicast
Mode Global Config