Kontron CP6923, Справочное руководство, Страница: 205 / 480

CP6923 Quality of Service (QoS) Commands
Page 3 - 31 CP6923 CLI Reference Manual
3.8.2.1 no ip access-list
This command deletes the IP ACL identified by <name> from the system.
3.8.3 ip access-list rename
This command changes the name of an IP Access Control List (ACL). The < name > parameter is the names of an
existing IP ACL. The <new name > parameter is a case-sensitive alphanumeric string from 1 to 31 characters
uniquely identifying the IP access list.
This command fails is an IP ACL by the name <new name > already exists.
3.8.4 {deny | permit} (IP ACL)
This command creates a new rule for the current IP access list. Each rule is appended to the list of configured rules
for the list.
A rule may either deny or permit traffic according to the specified classification fields. At a minimum, either the every
keyword or the protocol, source address, and destination address values must be specified. The source and
destination IP address fields may be specified using the keyword ‘
any
’ to indicate a match on any value in that field.
The remaining command parameters are all optional, but the most frequently used parameters appear in the same
relative order as shown in the command format.
Format
ip access-list <name>
Mode Global Config
Format
no ip access-list <name>
Mode Global Config
Format
ip access-list rename <name> <newname>
Mode Global Config
Note: The 'no' form of this command is not supported, since the rules within an IP ACL cannot be deleted
individually. Rather, the entire IP ACL must be deleted and re-specified.
Note: An implicit 'deny all' IP rule always terminates the access list.
Note: For BCM5630x-based systems, the mirror and redirect parameters are not available.
Note: For BCM5650x-based systems, the
mirror
parameter allows the traffic matching this rule to be
copied to the specified
<slot/port>
, while the redirect parameter allows the traffic matching this rule
to be forwarded to the specified
<slot/port>
. The
assign-queue
and
redirect
parameters are
only valid for a
permit
rule.