IBM Netfinity 3500 M10, Руководство пользователя

Страница: 73 / 268

8. To exit from the Configuration/Setup Utility program, press Esc
and follow the instructions on the screen.
Understanding power management
Your server comes with built-in energy-saving capabilities. You can
view and change energy-saving settings using the Power
Management menu in the Configuration/Setup Utility program.
This section describes the Power Management features in your
server and provides instructions for using these features.
Attention: If a device, such as a monitor, does not have
power-management capabilities, it can be damaged when exposed to
a reduced-power state. Before you make energy-saving selections
for your monitor, check the documentation that comes with your
monitor to see if it supports Display Power Management Signaling
(DPMS).
Setting power-management features
With Power Management, the server and monitor (if a monitor is
attached and the monitor supports DPMS) can be set to go into a
reduced-power state if they are inactive for a specified length of
time.
Ÿ
Time to Low Power: With this option, you can specify the
amount of time that the server must be inactive before Power
Management options begin to take effect. You can select from 5
minutes to 1 hour.
Ÿ
System Power:
With this option, you can select On if you want
the server to remain on, or Off if you want the server to shut
down.
Ÿ
Display: With this option, you can select one of the following
reduced-power states:
– Standby: In this mode, the screen is blanked, but the screen
image is restored immediately when any activity is detected.
– Suspend: In this mode, the monitor uses less power than in
Standby mode. The screen is blanked, but the screen image
is restored within a few seconds after any activity is detected.
Chapter 3. Configuration/Setup Utility program
55