IBM Netfinity 3500 M10, Руководство пользователя

Страница: 71 / 268

for the location of the switch. Move the switch to the ON
position. (To do this, push on the ON side.)
4. Replace the cover and reconnect the cables.
5. Set, change, or delete your administrator password in the
Configuration/Setup Utility program. Refer to “Setting or
changing an administrator password” on page 48 or “Deleting
an administrator password” on page 49 for instructions.
Note: You must know the administrator password to change or
delete it.
6. Disconnect all cables and remove the cover.
7. Move the switch back to the OFF position after you have set,
changed, or deleted your password.
8. Replace the cover, reconnect the cables, and then turn on the
server.
Erasing a lost or forgotten administrator password protected by
enhanced security
When enhanced security is enabled, it is vital that you keep a record
of your administrator password in a secure place. If you forget or
lose the administrator password, the system board in your server
must be replaced in order to regain access to the
Configuration/Setup Utility program.
Setting the startup sequence
Your server can be started (or booted) from several devices
including the hard disk drive, diskette drive, CD-ROM drive, and
from the network. The startup program looks for these devices in a
selected sequence. The Configuration/Setup Utility program is used
to select the startup sequence.
Note: The hard disk drive is the default startup device when no
other devices are ready. It does not appear in the choices
provided by the Configuration/Setup Utility program.
To set the startup sequence:
1. Start the Configuration/Setup Utility program (see “Starting and
using the program” on page 19).
Chapter 3. Configuration/Setup Utility program
53