IBM Netfinity 3500 M10, Руководство пользователя

Страница: 70 / 268

Configuration/Setup Utility program until your administrator
password is entered. This means that any changes in server
hardware that are detected by the system programs in your
server, such as removal of a memory DIMM, will generate a
configuration error until the administrator password is entered.
Enabling and disabling enhanced security
Enhanced security can be enabled or disabled only when you
update the system programs in your server.
To enable or disable enhanced security:
1. Insert a system programs update diskette into drive A in your
server. System programs updates are available on the World
Wide Web at http://www.ibm.com/pc/support/.
2. Turn on the server. If it is on already, you must turn it off and
back on again.
3. The update begins, your server halts, and you are prompted for
your administrator password (if you have set an administrator
password). The server remains in a halted state until you enter
the administrator password.
4. When you enter the administrator password, the update diskette
will continue to run, and you are given the option of enabling
or disabling enhanced security. Your choice is automatically
recorded in the System Security menu of the
Configuration/Setup Utility program.
Setting, changing, and deleting an administrator password protected by
enhanced security
To set, change, or delete an administrator password protected by
enhanced security, do the following:
1. Turn off all attached devices and the server.
2. Refer to “Disconnecting cables and removing the cover” on
page 76 for instructions on safety, disconnecting all cables
attached to the server, and removing the server cover.
3. Locate the switch marked as 7 on the rocker switches on the
system board. Refer to the system board label inside the server
52
Netfinity 3500 M10 User's Handbook