IBM Netfinity 3500 M10, Руководство пользователя

Страница: 66 / 268

Setting or changing an administrator password
Use the Configuration/Setup Utility program to set or change an
administrator password. You can use any combination of up to
seven characters (A–Z, a–z, and 0–9) for the password.
Important
Keep a record of your administrator password in a secure place.
If you lose or forget the administrator password, you will not be
able to access the Configuration/Setup Utility program, and you
will not be able to erase and reset an administrator password. If
you lose or forget your password, you must complete one of the
following steps in order to regain access to the
Configuration/Setup Utility program:
1. If enhanced security is disabled (default setting), you must
remove the server cover and move a jumper on the system
board. (Refer to “Erasing a lost or forgotten administrator
password” on page 49 for further information.)
2. If enhanced security is enabled, you must replace the system
board in your server.
To set or change an administrator password:
1. Start the Configuration/Setup Utility program (see “Starting and
using the program” on page 19).
2. Select System Security from the Configuration/Setup Utility
program menu.
3. Select Administrator Password.
4. Type your password and press Down Arrow (
↓
).
5. Type your password again.
6. At Power-On Password Changeable by User, select Yes or No.
Press Left Arrow (
←
) or Right Arrow (
→
) to toggle between
selections. (If you select Yes and an administrator password is
set, the power-on password can be changed without having to
enter the administrator password. If you select No and an
administrator password is set, the power-on password cannot be
changed unless the administrator password is entered.)
48
Netfinity 3500 M10 User's Handbook