Setup & Operation 3. Installation
RC620 Rev.8
25
If the Controller must be used in an environment that does not fulfill the conditions
mentioned above, take adequate countermeasures. For example, the Controller may be
enclosed in a cabinet with adequate ventilation and cooling.
- Install indoors only.
- Place in a well-ventilated area.
- Keep away from direct sunlight and radiation heat.
- Keep away from dust, oily mist, oil, salinity, metal powder or other contaminants.
- Keep away from water.
- Keep away from shocks or vibrations.
- Keep away from sources of electronic noise
- Prevent the occurrence of strong electric or magnetic field.
3.2.2 Installation
The controller can be placed vertically and horizontally.
When you place it vertically, place the left side (from front side view) down.
Also, put the rubber feet on the bottom to the left side.
Use the same screws for securing the rubber feet.
Position of set screws for rubber feet
Make sure to keep the controller away from the peripherals for the air supply and exhaust.
Controller Front side: 100 mm // Rear side: 150 mm
The rear side exhausts the hot air (approx. 10 deg C higher than ambient temperature).
Therefore, make sure that heat sensitive devices are not placed near the outlet.
There must be room in front of the Controller so that the entire Controller can be pulled
outward.
There must also be room behind the Controller so that one can attach and remove cables.
Use a base table that is at least 100 mm off the floor. Placing the Controller directly on the
floor could allow dust penetration leading to malfunction.
Содержание RC620 CU
