Delta ASDA-A3 Series, Руководство пользователя

Страница: 755 / 845

Troubleshooting ASDA-A3
13-10
13
AL007 Excessive deviation of Speed command
Trigger condition
and cause
Condition: deviation between the Speed command and the feedback speed
exceeds the allowable range (P2.034).
Cause:
1.
A drastic change in speed.
2.
Incorrect setting for P2.034.
Checking method
and corrective action
1.
Use the signal detector to check if the input analog voltage signal is normal.
If not, adjust the signal changing rate or enable the filter function.
2.
Check and make sure the value of P2.034 (Speed command error warning)
is correct.
How to clear the
alarm?
DI.ARST
AL008 Abnormal pulse command
Trigger condition
and cause
Condition: the input frequency for the pulse command is over the allowable value
for the hardware interface.
Cause: the pulse command frequency is higher than the rated input frequency.
Checking method
and corrective action
Use the scope to check if the input frequency is higher than the rated frequency.
Correctly set the input pulse frequency.
How to clear the
alarm?
DI.ARST
AL009 Excessive deviation of Position command
Trigger condition
and cause
Condition: deviation between the Position command and the feedback position
exceeds the allowable range (P2.035).
Cause:
1.
The maximum position deviation is set too low.
2.
Gain value is set too low.
3.
Torque limit is set too low.
4.
Excessive external load.
5.
Improper setting for the E-Gear ratio.
Checking method
and corrective action
1.
Check the value of the maximum deviation (P2.035 Excessive deviation of
Position command warning). If the value is too low, set a higher value.
2.
Check if the gain value is appropriate for the application.
3.
Check if the torque limit setting is appropriate for the application.
4.
Check the external load. Reduce the external load or re-evaluate the motor
capacity if necessary.