Delta ASDA-A3 Series, Руководство пользователя

Страница: 288 / 845

ASDA-A3 Motion Control
7-91
7
7.3.3 E-Cam gears and curve scaling
In the E-Cam system, two sets of E-Gears can determine the E-Cam motion, which are E-Gears
of the master axis and E-Gears of the slave axis. The E-Gears of the slave axis is the same as
that of the whole servo system. Their E-Gear settings are both determined by P1.044 and
P1.045. Changing this E-Gear ratio will change the E-Cam motion and motion commands in PT
and PR modes as well. Therefore, if you need to change the E-Cam curve scaling, changing
P1.044 and P1.045 is not suggested.
The E-Gear of the master axis is only for the E-Cam system and can change the pulse
command resolution of the master axis. The setting parameters are P5.083 and P5.084. When
the slave axis receives the pulse number defined by P5.084 from the master axis, E-Cam
rotates the number of cycles defined by P5.083 (one cycle of E-Cam = rotate from 0° – 360°).
(1)
E-Gear of master axis: P5.083 and P5.084 for command pulse resolution
(2)
E-Gear curve: P5.019 for scaling
(3)
E-Gear of slave axis: P1.044 and P1.045 for output signal resolution
Figure 7.3.3.1 E-Cam gear ratio