CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 6 / 365

CFMOTO
01-2
9.Replace aged rubber parts when assembling. Do not splash gasoline, grease onto the
surface, as this could cause damage.
10. Apply or inject recommended lubricant into the specified lubrication points.
11. Use the correct special tools for removal and installation.
12. When a ball bearing is removed by pressing steel balls, it can not be reused.
·Replace bearings if the axial or radial free play is too big.
·If the running surface feels uneven, clean with oil and check. Replace it if the cleaning
does not work.
·When pressing the bearing into the machine or onto the shaft, if the bearing can not
be securely seated, replace it.
13. Install one-side dust-proof bearings in the right direction. When assembling open type
or double-side dust-proof bearings, install with the manufacturer’s mark outward.
14. Install the elastic circlips properly. Turn the circlip after assembling to make sure it has
been installed into the slot.
15. After assembling, check that all the tightened parts are properly tightened and can
move smoothly.
16. Brake fluid and coolant may damage painting, plastic and rubber parts. Flush with
water if splashed on these parts.
17. Install oil seals with the side of manufacturer’s mark outward.
·Do not fold or scratch the oil seal lip.
·Apply grease to the oil seal lip before assembling.
18. When installing pipes, insert the pipe until it bottoms in the end of the joint. Fit the pipe
clip, if any, into the groove. Replace the pipes or hoses that cannot be tightened.
19. Do not allow mud or dust into the engine and/or the hydraulic brake system.
20. Clean the gaskets and washers off the engine casing before assembling. Remove the
scratches on the joint faces by polishing evenly with a polish stone.
21. Do not twist or bend the cables too much. Distorted or damaged cables may cause
poor operation or even damaged components.
22. When assembling the parts with protection caps, insert the caps to the grooves.