CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 180 / 365

5.3 Crankcase, Crankshaft and Gears
05-105
1 Retainer 3 Reverse Intermediate Gear
2 Washer 4 Needle Bearing
5 Boss on Reverse Intermediate Gear
0510501
Installation
Crankcase installation procedure is the
reverse the removal procedure. However,
pay attention to the following details:
Do not use a hammer to install ball bearing
unless its structure is special. Only use a
press tool to install a bearing.
If necessary, heat crankcase up to 100ºC
before install the bearing.
Warning: Clean oil, inside and outside,
from crankcase before heating.
Put a new ball bearing in an icebox or
equivalent facility to chill for 10 minutes
before installation.
Use sevice tool to install the ball bearings
in left crankcase and right crankcase.
Note: Always support crankcase
properly when installing ball bearings.
Perform the correct procedure when
installing a new oil seal(refer to Oil Seal
Installation above).
Tool:
Bearing 6203 push rod
152MI-060002-921-002 Bearing 3206A
push rod
CF188-012100-921-004
Bearing 6303 pressor
CF188-011100-921-004
Bearing 6203 pressor
1P39MB-012001-921-002
Other Parts in Crankcase
Reverse the removal propcedure for
installation to in-stall the reverse
intermediate gear.
Note: The boss of the intermediate
gear should be face inside by following the
drawing on the right.
5
2 4
2 1
3