CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 316 / 365

CFMOTO
06-6
060601
060602
060603
060604
PCV
Removal: (See picture 060601)
Remove bolt 1 to remove PCV 2.
Installation:
Reverse the removal procedure.
NOTE: Refer to 1.7.2 to arrange the
brake pipe routing. If front and rear braking
system are not working together, check for
leaking or jammed lines.
Rear brake caliper
Removal: (See picture 060602)
Remove bolts 1 and remove caliper 2.
Installation:
Reverse the removal procedure for
installation.
NOTE: Inspect the brake switch and
brake light function to make sure it is
working.
6.4 Suspension system
Front suspension system
Removal:
(See pictures 060603, 060604)
Set the vehicle on flat ground. Use lifting
jack to lift up the vehicle and support on
the frame.
Remove front wheel.
Remove front protector of suspension.
Remove brake caliper.
Remove wheel hub and brake disc
assembly.
Remove shock absorber bolt and nut 1.
Remove shock absorber 2.
Remove cotter pin and locking nut 6 of
steering tie rod.
Remove cotter pin and nut 5 assembled
on steering knuckle.
Remove locking bolt 7 assembled on
steering knuckle.
Remove steering knuckle from CV shaft.
Remove A-arm mounting bolt and nuts 3.
Remove upper A-arm 4 and lower A-arm 8.
Installation
:
Reverse the removal procedures for
installation.
NOTE: Front suspension system RH
is same as the LH method.
1
2
1
2
1 2
3
8 7
5
4
6