CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 288 / 365

5.9 Electrical System
05-213
5.9.5.3 PDA Function
(A) Version Infomation Display
PDA can display engine, ECU hardware and soft ware information.
(B) Fault Display
PDA monitors IAP sensor,IAT sensor, coolant temperature sensor, TPS, O2S, O2S
heater circuit, air-to-fuel ratio revision, fuel injector, fuel pump relay, CPS, speed signal,
idle speed, idle air control valve, system voltage, ECU, FI indicator and displays the fault
code.
5.9.5.2 PDA
PDA uses OBD standard line. Just connect
the cable to diagnose connector.
Picture shows the PDA key functions.
Please read the PDA owners manual for
more details.
Note: Remove the K-line before
diagnosing.
Key function:
LH Key: Page up
UP Key: Scroll Up
RH Key: Page Down
Down Key: Scroll Down
OK Key: Entrance
EXIT Key: Exit
0521301
(C) Engine Data stream Display
PDA can display battery voltage, RPM, desired idle speed, vehicle speed, coolant
temperature, coolant temperature sensor signal voltage, inlet air temperature, IAT sensor
signal voltage, inlet air pressure, inlet air flow, IACV target position, TPS signal voltage,
throttle body position, throttle body relative position, canister duty, charging time, FI
pulse width, park advance angle, O2S voltage, engine relative load, cansiter load, IACV
position, atmospheric pressure, altitude multiplier, engine operation time.
(D) EFI Status Display
Starter switch, main relay, fuel pump relay, idle speed, idle speed, full load status,
deceleration activation, acceleration activation, FI close loop activation, lambda control
activation, canister control valve activation, MIL status.
(E) Actuator Test Function
MIL, fuel pump, IACV, canister control valve, ignition, fuel injection.
1 UP Key 4 EXIT Key 7 Power
2 LH Key 5 OK Key
3 RH Key 6 Down Key
1
2
4
6
5
3
7