CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 323 / 365

06 Vehicle chassis
06-13
061302
Remove the front wheels.
Remove nut of steering tie-rod and
steering column 25. To remove the tie
rod 27. Remove the bolt 20 . Remove the
steering rocker arm 22.
Use screw driver and hammer to flat the
piece 5.
Remove 2 bolt 4.Remove steering shaft
12.
Installation
Reverse the removal procedure for
installation.
NOTE: Refer to Chapter 1 to route and connect the cables and lines. After assembly,
make sure the steering moves freely through the full range of motion. When assembling
the steering arm, set it in the middle position and then install the steering shaft. Make
sure the steering angle is the same as installed before tightening fasteners.
EPS Steering system (See picture 061302)
1 Bolt M8×55 11 EPS steering shaft 21 Nut M10×1.25
2 Handle bar cover 12 BoltM8×35 22 Washer 10
3 Steering shaft sleeve 13 Washer 8 23 Steering rocker arm
4 Bolt M8×75 14 EPS driver 24 Washer 12
5 Locking piece 15 Bolt M6×30 25 Nut M12×1.25
6 Fardage 16 Sleeve 26 Cotter pin 2.0×16
7 Steering shaft outer sleeve 17 Bolt M8×25 27 Steering rod
8 O-ring 32×1.8 18 Steering seat mounting
bracket
28 EPS controller
9 Steering shaft inner ball sleeve 19 Bolt M10×20
10 Sleeve 20 Cotter pin 2.0×16
12
5
4
061301