CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 324 / 365

CFMOTO
06-14
061401
Removal
Remove body covering parts.
Remove 4-wheel hand brake lever.
Remove hand brake master cylinder.
Remove handle bar pipe (Including electric connectors).
Use screw driver and hammer to make the locking plate 5 flat.
Remove 2 bolt 9.
Remove the bolt 13.
Lift up the EPS steering shaft 24 to remove the shaft.
Installation
Reverse the removal procedure for installation.
NOTE: Refer to Chapter 1 to route and connect the cables and lines. After assembly,
make sure the steering moves freely through the full range of motion. When assembling
the steering arm, set it in the middle position and then install the steering shaft. Make
sure the steering angle is the same as installed before tightening fasteners.
EPS motor
Removal
Remove EPS steering shaft (See picture
061302).
Remove the connector 1 (See picture
061401).
Remove the front wheel.
Remove steering rod locking nut 21.
Remove the steering rod 27.
Remove the bolt 13 and nut 25.
Remove steering rocker arm 23.
Remove 4 bolt 19 (See picture 061302).
Remove the steering shaft bracket 23 (See
picture 061303).
Remove bolt 16.
Remove EPS motor 14 (See picture
061302).
Installation
Reverse the removal procedure for
installation.
NOTE:
Refer to Chapter 1 to route and connect the cables and lines. After assembly, make
sure the steering moves freely through the full range of motion. When assembling the
steering arm, set it in the middle position and then install the steering shaft. Make sure
the steering angle is the same as installed before tightening fasteners.