CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 163 / 365

CFMOTO
05-88
058802
058801
1 Driven Bevel Gear Limiting But Socket
(P/N:0800-062206-922-001)
2 Driven Bevel Gear Bearing Seat
1
Bevel Gear
Bearing
Seat
2 Bevel
Gear 3
Cover 648
Cylinder
Locking Glue
Position
Use bench vice to fix bearing carrier, then
remove bearing and use special wrench
(0800-062206-922-001) to remove thrust
nut, finally remove bearing.
Gear Inspection
Inspect gear for any surface damage,
wear. Replcae the drive and driven gears
together if necessary.
Inspect bearing for operation condition.
Replace the part if any trouble inspected.
Otherwise, no need to remove.
Gear Installation
Installation procedure is the reverse of
removal procedure. Pay attention to the
details:
Use oil seal
installer(0800-062204-923-001) to install
NEW oil seal and O-ring.
When replacing the right crankcase, ring
gear or bearing seat,the adjustment shiim
should be adjusted again(see Bevel Gear
Clearance Adjustment)
Cover the 648 cylinder locking glue
between gear and bearing surface when
assembly(see right pic). Do not cover
on spline. O-ring should be cover with
engine oil. Oil seal lip must be covered
with grease. Bearing locking nut should be
covered with 243 thread locker. And tight
up in specific torque with special tool.
Tighten torque: 110N·m
Tool:
Bearing 6305 pressor CF188-062103-
921-002 Bearing 6207C3 pressor CF188-
062201-921-003
2
1 3
2
1