CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 209 / 365

CFMOTO
05-134
5.5.5 Gear Box Oil Inspection
Ensure the vehicle is on flat surface.
Start the engine and run the engine for
several minutes. Stop the engine and wait
for several minutes to make sure the gear
oil totally flew back to bottom. Unscrew
dipstick and wipe the oil residue off, then
put dipstick in the hole. Don’t screw in
dipstick to read oil level, just make dipstick
threads contact the hole surface;
Remove dipstick and read oil level;
Engine oil level must be between “upper”
and “lower” marks;
If oil level is below “lower”, refill and
inspect again and again until it is OK.
Tighten the oil dip stick back.
Note:
Strictly follow the procedure above,
otherwise wrong oil level may be indicated;
Vehicle must be placed on a level surface;
Don’t screw in dipstick to read oil level
5.5.6 Gear Oil Replacement
Ensure the vehicle is on flat surface before
start working
Note: The gear case can be very hot.
Wait until gear oil is cooled down.
Place a drain pan under the gear box oil
drain bolt.
Clean the drain bolt area.
Remove the oil dipstick
Remove the drain bolt and the drain bolt
sealing gasket to drain the gear oil.
Note: When draining the gear oil,
remove oil dipstick first to release the
pressure, in case of oil spilling out.
Oil level:
1 Upper 2 Lower
1 Drain Bolt 2 Sealing
Gasket 3 Oil dipstick
0513401
0513402
1
2
1
2
3