CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 245 / 365

CFMOTO
05-170
1 Washer 2 Bleeding Screw
1 Thermostat Cover 2 Screws
0517002
0517001
With vehicle on a flat surface, refill radiator
with coolant. When coolant comes out of
the thermostat housing hole, install the
bleeding screw and washer. Torque to
5N.m (44 Ibf.in).
Fill up the radiator and install radiator cap.
Fill the reservoir tank and keep the coolant
level even at “LOWER” mark, then install
reservoir tank cap. Run the engine until
thermostat opens, then shut off the engine.
Recheck the coolant level in reservoir
tank after the engine is completely cooled
down. Refill coolant if necessary.
Maintain coolant level between “LOWER”
and “UPPER”.
Note: Each year or every 100 hours or
when vehicle reaches 3000km (1865mi),
check coolant concentration (freezing
point) with a proper tester.
5.8.5 Thermostat
The thermostat is a single way valve.
Note: Thermostat is located on the
top of cylinder head, on intake side(front
cylinder).
Thermostat Removal
Dain the coolant from the system.
Remove thermostat housing screws and
pull thermostat housing.
1
2
1
2