CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 235 / 365

CFMOTO
05-160
1 Clamp 2 Air Filter 3 Air Filter Cover
1 Locking Clamps 2 Air Filter Cover
5.7.2 General
During assembly/installation, use the
torque values and service materials as in
the exploded views.
Warning:
Torque wrench must be used when
tightening.
Locking devices (e.g.:Locking tabs, elastic
lock nuts, cotter pin, etc.) must be replaced
with new ones.
Do not cut down or modify any parts of the
air intake system. The engine management
system has been adjusted accurately for
the components. Otherwise, the engine will
be low on power or even damaged.
5.7.3 Air Filter
Removal
Remove the seat pad and housing cover
(See Body Covering parts).
Loosen the locking clamps (1) to remove
the air filter cover (2).
Loosen the clamp to remove the air filter
element.
Note: If vehicle is used in dusty areas,
inspect more frequently than specified in
the maintenance chart.
If liquid/deposits are found, wash, squeeze
and dry the foam pre-filter. Replace the
main filter element if damaged.
Warning: Do not start engine if liquid or
deposits are found. If there is oil in the air
filter housing, check engine oil level. Oil
level may be too high.
Pour air filter cleaning solution or an
equivalent into a bucket. Put the foam pre-
filter in to soak. Do not wash the main filter
element.
While the pre-filter soaks, clean inside of
the air filter housing.
0516001
1
2
0516002
1
3
2