CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 147 / 365

CFMOTO
05-72
1 Breather Gear 3 Oil Pump
Intermediate Gear
2 Breather
Intermediate Gear 4 Oil Pump Gear
057201
5.3.2 General
During assembly/installation,use the torque
value and serivce products as shown in
the exploded view(s).
Clean the screw before applying the thread
locker.
Warning: Torque Wrench Tightening
specifications must strictly be adhered to.
Locking devices(e.g.: lock ing tabs, elastic
stop nuts, self-locking fasteners, cotter pin,
etc) must be replaced with new ones
where specified.
Note: Before disassembly, drain engin
oil and engine coolant.
5.3.3 Drive Gear
The drive gears are located on the MAG
side behind the magneto cover.
Removal
Remove:
-Magneto cover(refer to Mageneto Cover
Assy)
-Retainer ring No.10
-Magneto, driven gear
-Oil pump intermediate gear
-Breather intermediate gear
-Oil pump gear
-water pump gear
-Breather gear
Inspection
Inspect oil pump inter gear/breather inter
gear/oil pump gear for wear or other
damage, replace a new one if damaged.
Breather Gear
The engine is equipped with a breather
gear in order to prevent engine oil coming
out though the breathing system into the
air box.
Inspect gear for wear or damage .
Check ball bearing for excessive play and
smooth operation .Replace breather gear
assembly if necessay
Installation
The installation is essentially the reverse
of the remove procedure, but pay attention
to the follow details:
4
3
2
1