CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 208 / 365

05-133
5.5 Engine lubrication system
5.5.4 Engine Oil Replacement
Ensure vehicle is on a level surface before
working. Replace engine oil and filter
element at the same time when engine is
warm.
Note: The engine oil can be very hot.
Wait until engine oil is warm.
Place a drain pan under the engine oil
drain plug area;
Clean the drain plug area;
Unscrew oil dipstick, drain plug and
discard the gasket ring;
Wait sevearal minute. Allow oil to drain
completely from crankcase;
Note:
Oil condition gives information about
the engine condition. Check the drained
engine oil for engine shavings and residue.
Presence of debris indicates a failure
inside the engine. Check engine to correct
the proplem.
Clean the drain plug. If the sealing washer
damaged, replace the washer and tighten
the plug up.
Drain plug tightening torque: 20N·m
Replace oil filter element refer to Oil Filter
further in this section;
Refill engine with recommended engine
oil through dipstick hole;
Oil capacity(With filter): 2.5L
After filling, check engine oil level with
dipstick(refer to Engine Oil Level Check
above).
Install dipstick. Run the engine to ensure
oil filter and drain plug areas are not
leaking;
1 Drain Plug 2 Washer
0513301
2
1