CF MOTO CF1000ATR 2018, Руководство по обслуживанию, Страница: 330 / 365

CFMOTO
06-20
062001
1 Sealing washer 2 Front axle drain bolt
3 Sealing washer 4 Front axle fill bolt
062002
1 Sealing washer 2 Rear axle drain bolt
3 Sealing washer 4 Rear axle fill bolt
6.6.3 Front/Rear gear case oil replacement
Make sure the vehicle is on flat ground
before working.
NOTE:
The front and rear gear case
temperature may be very high. Make
sure it is cooled down before working.
Set a suitable container under the front/
rear gear case.
Clean the drain bolt area.
Remove the drain bolt 2 and sealing
washer 1 (See 062001, 062002).
Wait few minutes to make sure the oil is
completely drained out.
Clean the oil drain bolt area.
Install the drain bolt and sealing washer.
Tighten to the specified torque;
Tighten torque: 25N·m
Remove the oil fill bolt 4 and sealing
washer 2 (See 062001, 062002).
Fill the lubricating oil:
Oil capacity: Front 0.23L / Rear 0.40L
Install the fill bolt and sealing washer.
Tighten to the specified torque;
Tighten torque: 25N·m
NOTE: If a sealing washer is damaged,
replace with a new one. Do not install
without a sealing washer or leaking will
occur.