Skyranger Nynja, Build Manual

Page: 146 / 278

146
Nynja Build Manual 1.4d
Figure 180 Arm should align with vertical part of throttle handle
j) Bolt the arm into position using the 6mm bolt and 6-22 saddle washer between
arm and torque tube.
k) Refit the torque tube onto the mounting plates
l) Rivet the plates into position to the cabin uprights tu34 , using 4mm steel
rivets.
m) Adjust the throttle friction by tightening the lock nuts on the port side torque-
tube spindle.
The starboard side should be done up just enough to remove any play.
n) Once the friction has been set, lock the two friction nuts together at both ends.
o) Check that the spacing and centralisation of the parts holding the tops of the
cabin uprights has not been disturbed by the fitment of the throttles.